Fabrication Lab Open Hours
Open lab hours for the fabrication labs are as follows. Hours will remain the same until the end of the quarter, unless otherwise specified.
(Labs opening soon, some hours were posted previously, these were left over from last year and do not apply.)
As always, please respect the open lab rules:
Safety stickers are required to enter.
Proper lab attire is required to enter.
Labs are on a first come first serve basis
For questions about open labs, please contact Ed Lau email@example.com or Kurtis Wragg firstname.lastname@example.org
Good luck, be safe, and build some incredible robots!
Three person teams
Full length pants required
No open toe shoes
No food or drinks
Clean up stations after you leave
Pre-lab assignments, lab write-ups, and homeworks must be turned in
during the first 10 minutes of lab. 10% off for late assignments.
Tuesday 8-10:50 (Quentin, Diogo)
Tuesday 11-1:50p (Edward,Diogo)
Tuesday 2-4:50p (Patricio, Joan)
Thursday 8-10:50 (Quentin, Nathan)
Thursday 11-1:50p (Quentin, Belane)
Thursday 2-4:50p (Patricio, Edward)
Thursday 5-7:50p (Nathan, Joan/Diogo)
Friday 8-10:50p (Quentin, Belane)
Using the oscilloscope, function generator, breadboard, potentiometer, and microcontroller
Introduction to data acquisition systems and filters
Open-loop control of a DC motor
Closed-loop control of a DC motor
PD Controller of motor position